最近我们替换客运侧功率镜像上1997S-10Blazer.Blazer老板离停车场支持列太近,并打破链面镜片
工具使用安装
- 7mm坚果驱动
- 10mm套接字
- 扁头螺旋
- 菲力浦头螺旋树
- 门板清除工具
优先匹配新部件最好现在就发现 后你全门破解
某些车辆上有一个小型存取板需要去除以揭开安装螺栓或坚果。小存取板更容易反射替换,通常只有2或3个塑料门剪片连接在一起。 我们1997S-10Blazer不幸没有这个存取板,所以我们不得不删除全内部门板替换
多数门板由几根螺旋管、塑料门板剪片和窗口下唇拉开
We first removed two 7mm bolts inside the door pull handle. There was also a trim screw on the door handle bezel. The window and lock switch panel can also be removed for easier access to the plastic door panel clips inside. Once the hardware is removed, take your door panel clip removal tool and wedge it between the door and the door panel itself, slide the tool along until the tool runs into a clip. Position the tool so the clip is in the middle of the fork, and pry the clip out. Use of a door panel clip removal tool lessens the chances of damaging the door panel, and in most cases you can also reuse the clips.
硬件关闭后 剪片从后门面板释放 谨慎地把门面板向上拉开窗口
门面板只由内门板belzel和手柄控制, 但你可以转动它访问镜装孔
接下去你需要伸入门中并断开镜电线。然后去掉存取漏洞上3个泡沫橡皮覆盖物,并去掉把镜对门的310毫米坚果
避免把坚果丢进门面板并完全毁了你的一天:
第一步安装插件新镜像,并确保它正常工作
下一端用10毫米坚果重新安装镜像(记住涂油技巧 ) 。 并重安装门板检查塑料剪片确定无故障重安装2至7毫米螺栓拉柄和门柄修剪螺丝